Bio Tech Valves
Tank Bottom Valves PDF Print E-mail
The design of the GEMÜ Tank Bottom Diaphragm Valve is based on the design of the standard diaphragm valve. However, unlike conventionally available tank valves, the GEMÜ Tank Bottom Valve is machined from solid bar stock.  Also, since this valve is not a welded construction, there is no reason to worry about non-fully penetrated or defective welds, which are potential areas of contamination.
Read more...
 
GMP & SAP Valves PDF Print E-mail

The GEMÜ GMP (Good Manufacturing Practice) Valve is typically installed in a vertical position and the SAP (Sterile Access Port) valve in the horizontal position.

The funtion of a “T” fitting and a branch valve is combined into the valve body. The third port is located in line with the weir (point of seal). 

Read more...
 
Custom Fabrications PDF Print E-mail
GEMÜ offers a wide range of custom designed multi-ported single block valve assemblies and cluster valve fabrications, which in most cases are designed in close cooperation with the customer (an engineering company, contractor or end user).

The valve fabrication or "valve cluster" is designed on AutoCAD, which enables easy daily exchange between the customer and GEMÜ. This enables GEMÜ to keep turn around time of a new design to a minimum.
Read more...
 
U-Bends PDF Print E-mail


GEMÜ offers the "Zero Static T-Valve" and U-bend with an integrated sample valve, which is called the "Duplex Valve".

As pictured, the sample valve (size 1/4" to 1/2") is machined into the opposite side of the T-Valve, ensuring full drainability and a zero deadleg.

 
<< Start < Prev 1 2 3 Next > End >>

Results 5 - 8 of 10